Worcester Si Mk II Manual de Instruções descarregar pdf (Página 27)

DIGISTAT

INSTALLATION

DIGISTAT / DT10RF RECEIVER

SETTING UP THE RF LINK

Receiver set up:

After initial start up, the colon, CH and antenna

symbols should be flashing on the display.

1. Press the set? button 4 times

2. Press the OK button once

3. Press the set? button 4 times; Lrn and OFF

should be displayed

4. Press the + button so the display shows ON and

a flashing antenna symbol. The learn mode is now

ready to receive a signal from the transmitter

during the next two minutes.

Transmitter set up:

1. Take the Digistat Programmer unit and stand near

the boiler.

2. Remove the battery cover and fit the batteries.

How to fit the batteries

Remove the battery cover using a coin. Insert 2 x

1.5V (AA) Alkaline batteries ensuring correct orienta-

tion. Replace the battery cover pressing fully home.

Transmitter battery compartment

Digist

DT10RF PROGRAMMER

INSTRUCTION MANUAL

8 716 115 493a (02.2009)

OPERATING & INSTALLATION

INSTRUCTIONS

8_716_115_493a 9/2/09 09:46 Page 27

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 35 36

Sem comentários

Worcester Si Mk II Manual de Instruções Página 27